Hot Product

Product drawing»

Structural drawing»

You are here:  

High RPM

2011-06-02

Hello well I’ve been having stalling problems on my 92 Mercedes Benz
400se I figured it was the throttle butterfly valve that was having a
hard time opening so I used fuel treatment and i cleaned the the butterfly valve.
Now after I turned it on the rpm in park and neutral is around 1800
which seems a little bit too high. However when it’s in drive its
normal. Reverse is the same except for a jerking motion after i put it
into reverse (the jerking happened after the cleaning) . On top of that
when in drive it seems like the car accelerates on its own.
Did you get the air intake tube back on correctly after cleaning the “throttle butterfly”?
A constant high engine idle is a classic issue caused most commonly by a vacuum leak.
A frequently used method by professional mechanics is the use of
starting fluid or brake wash. Simply spray around the engine with it
running ( not on the exhaust ) and listen for a change in engine noise.
Once You have found the area, turn the engine off and check for cracked

 

MORE NEWS

  • Chlorine ball valve
  • knowledge of butterfly valve
  • half ball valve
  • Hot water heater and gate valve
  • Shanghai MeiYan Yi Pump & Valve Co., Ltd.
    MeiYan Yi solenoid valve Contact MeiYan Yi
    Shanghai Enine Pump & Valve Co., Ltd.
    Enine solenoid valve Contact Enine
    Shanghai Saitai Pump & Valve CO., Lid.
    Saitai solenoid valve Contact Saitai
    Shanghai Fengqi Industrial Development Co., Ltd.
    FengQi solenoid valve Contact FengQi