Hot Product

Product drawing»

Structural drawing»

You are here:  

de-gradation of latching solenoids

2010-10-27

Using latching solenoids to divert water in domestic water pipes.
We see on datasheet that it takes one Watt of electrical power for 20ms to latch the solenoid.I don't know if it's mechanical wear products jamming the mechanism or interfering with the magnetic circuit, or aging of the permanent magnets with the magnetic circuit open, or what, but they've never lasted for me, and their lifetimes were short enough that I had no interest in trying to improve them.
Always ended up with two-current drivers and regular solenoids valve; high current pull-in, low current hold-in.If you are talking about irrigation valves latch solenoid types, they are really low cost products. They usually cost ~$1.5 to $2 to manufacture. They are not robustly designed. The electromagnetic force of solenoid has no margin for added friction or added spring force due to tolerances, dirt, etc. If the return spring is a little stronger the electromagnetic pull force due to coil will not be enough or the permanent magnet circuit force will not hold the plunger when the current is removed. On the other hand if the spring force is a little lower the plunger will stay stick due to the permanent magnet. When such solenoids are designed for military or aerospace the pull magnetic force should be 1.5 to 2 times stronger than the spring.


MORE NEWS

  • Non operable valves in Shell Mesc
  • Control valve straight run requirement
  • Triple eccentric seal
  • Plumbing a solenoid valve for PC50 excavator thumb
  • Shanghai MeiYan Yi Pump & Valve Co., Ltd.
    MeiYan Yi solenoid valve Contact MeiYan Yi
    Shanghai Enine Pump & Valve Co., Ltd.
    Enine solenoid valve Contact Enine
    Shanghai Saitai Pump & Valve CO., Lid.
    Saitai solenoid valve Contact Saitai
    Shanghai Fengqi Industrial Development Co., Ltd.
    FengQi solenoid valve Contact FengQi