Hot Product

Product drawing»

Structural drawing»

You are here:  

Control sets

2010-11-16

With a bypass its normally the same size or smaller than the control valve? But can the ball valve be directly attached to the tee. I thought it was not possible to get the bolts in if the flange was directled attached to the tee.
A weldneck flange attached to the tee should offer enough room for bolts.  Going with a fitting make-up like that saves one weld associated with installing a short piece of pipe.
I'm more accustomed to seeing globe valves used but I don't see there being much difference, piping wise.
A former colleague reckoned that you couldnt get the bolts in but Ive noticed in the models at this job im on all the control sets have a weldneck attached to a tee..then a globe valve straight to that.


MORE NEWS

  • sampling valve
  • multi-hole orifice valve
  • Pressure reducing valve working in the oppsite flow direction
  • Twin Seal DBB Valve Pressure Relief
  • Shanghai MeiYan Yi Pump & Valve Co., Ltd.
    MeiYan Yi solenoid valve Contact MeiYan Yi
    Shanghai Enine Pump & Valve Co., Ltd.
    Enine solenoid valve Contact Enine
    Shanghai Saitai Pump & Valve CO., Lid.
    Saitai solenoid valve Contact Saitai
    Shanghai Fengqi Industrial Development Co., Ltd.
    FengQi solenoid valve Contact FengQi